Boat lifts
A lift sized to the boat you actually own.
Four-post cradle lifts, elevator lifts and boathouse roofs, set on piles we drive ourselves so the rated capacity means something.
What you get
Capacity that starts at the pile, not the motor.
Piles and beams
Piles driven to bearing for the loaded weight of the boat, with aluminum or galvanized beams and cradle to match.
Motors and controls
Direct-drive or gear-drive motors, remote controls, and switch locations you can reach with a line in your hand.
Cover and access
Boathouse roof, catwalks on one or both sides, and a walkway height that still works at your low water.
How the job runs
The boat determines the lift. The water determines the piles.
Boat and water
Dry weight with fuel and gear, beam, and the depth at your dock at low water.
Permit and order
Permits where required, then lift components ordered to the measured spec.
Piles
New piles driven from the barge, or existing piles verified before we hang anything on them.
Set and test
Beams, cradle, motors and controls installed, then we run your boat up and down with you standing there.
Tell us what you want built.
A few questions about the property, the water depth and the boat. We will tell you what it takes and what it costs.